Package: powstatd
Version: 1.5.1-9.1
Architecture: i386
Maintainer: Ubuntu Developers <ubuntu-devel-discuss@lists.ubuntu.com>
Original-Maintainer: Peter S Galbraith <psg@debian.org>
Installed-Size: 113
Depends: libc6 (>= 2.7), debconf (>= 0.5) | debconf-2.0, debconf
Conflicts: powstatd-crypt (<< 1.5.1-3), ups-monitor
Replaces: powstatd-crypt (<< 1.5.1-3)
Provides: powstatd-crypt, ups-monitor
Section: admin
Priority: extra
Description: Configurable UPS monitoring daemon
 Assuming you have a relay-based "dumb" UPS that corresponds with your
 machine via a serial connection, you should be able to configure powstatd
 in just a few minutes. It is easily configured, and can be expected to
 support most "dumb" UPS supplies.
 .
 UPS models known to work:
  CyberPower PowerSL series
  CyberPower Power2000 1500VA
  CyberPower Power99 325VA, 400VA, 500VA and 720VA
  Some older CyberPower 385VA and 450VA models
  TrippLite Internet Office 500 UPS
  Various older APC units.
 .
 Powstatd can also be configured to allow a master machine to control
 (Via a network connection) up to 20 (by default) additional slave
 machines connected to the same UPS. This allows you to run several
 machines off the same UPS, with only one of the machines actually
 reading the UPS status over the serial line.  This version of powstatd
 uses secure cryptography to communicate between master and slave(s),
 replacing the older powstatd-crypt Debian package.
