#################################################
# Example MGEN script

#################################################
# These are some "Transmission Event" script lines

TXBUFFER 10000
# Here is a plain old constant bit rate flow to the loopback interface
0.0 ON  1 UDP SRC 5001 DST 127.0.0.1/5000 PERIODIC [1 4096]

# Here is a series of Poisson distributed packet transmissions 
# to a multicast group
0.0 ON  2 UDP SRC 5000 TXBUFFER 20000 DST 224.225.1.2/5001 POISSON [1 4096]

# Here is a "burst" transmission flow to the loopback interface
# The bursts are at regular 10 sec. intervals with fixed 5 sec. duration
0.0 ON  3 UDP DST 127.0.0.1/5000 \
BURST [REGULAR 10.0 PERIODIC [10.0 256] FIXED 5.0] 

# This will send ONE 5 megabyte TCP message
# Note that the target node must be listening to the destionation
# tcp address
#0.0 ON 1 TCP SRC 5000 DST 192.168.1.100/7000 PERIODIC [1 5242880] COUNT 1

4.0 MOD 2 PERIODIC [10 1024]

# To terminate flows after 10.0 seconds
10.0 OFF 1
10.0 OFF 2
30.0 OFF 3

#################################################
# These are some "Reception Event" script lines
0.0 LISTEN UDP 5000-5001,6000,6003

# This JOIN is for UNIX
0.0 JOIN 224.225.1.2 

# This SSM JOIN is for UNIX (Currently SSM is supported only in UNIX)
#0.0 JOIN 224.225.1.2 SRC 25.25.25.1

# For WIN32, the PORT option is needed for JOINs
#0.0 JOIN 224.225.1.2 PORT 5001

# For either, you can optionally dictate an interface, too 
# (WIN32 uses IP address for interface name)
#0.0 JOIN 224.225.1.2 INTERFACE eth0

5.0 LEAVE 224.225.1.2

# This SSM LEAVE is for UNIX (Currently SSM is supported only in UNIX)
#5.0 LEAVE 224.224.1.2 SRC 25.25.25.1 INTERFACE eth0

# If an interface was dictated on the JOIN, 
# it is also required for the LEAVE
#5.0 LEAVE 224.224.1.2 INTERFACE eth0

6.0 IGNORE UDP 5000

8.0 IGNORE UDP 5001,6000,6003

###################################################
# Listen to TCP socket 5000 at 10 seconds into test
20.0 LISTEN TCP 5000

# At 11 seconds into test, send 20 1024 byte 
# packets as fast as possible over the loopback
# interface 

21.0 ON 1 TCP DST 127.0.0.1/5000 PERIODIC [-1 1024] COUNT 20

# turn off the flow 1 at 15 seconds
25.0 OFF 1

# ignore port 5000 
25.0 IGNORE TCP 5000


