DLT_GATEWAY.CONF(5)

NAME
dlt_gateway.conf - DLT configuration file for gateway

DESCRIPTION
The configuration file dlt_gateway.conf allows one to configure the different runtime behaviour of gateway in Multinode feature.

The configuration file is written in an INI file format and contains information about different connected passive nodes.

If Multinode feature is enabled, dlt-daemon loads by default the configuration file /etc/dlt_gateway.conf.

An alternative configuration file can be loaded by changing GatewayConfigFile in dlt.conf(5).

GENERAL SECTION

  Interval
Time interval for reconnection to passive Node in second.

        Default: 1

PASSIVENODE SECTION
Each passive node’s connection parameters are specified in a unique numbered separate section

([PassiveNode{1,2, ...N}]).

        Example: [PassiveNode1]

  IPaddress
Because TCP is the only supported communication channel,

the IPaddress and Port of the Passive DLT Daemon has to be specified.

IP Address of passive node. Mandatory

  Port
TCP port. Default 3490 is used if no port is specified.

        Default: 3490

  EcuID
ECU identifier of passive node. Mandatory.

  Connect
With the Connect property it is possible to specify when the Gateway DLT Daemon shall connect to the passive node.

        Default: OnStartUp

The following values are allowed:

        OnStartup   The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                    immediately after the Gateway DLT Daemon is started.
        OnDemand    The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                    when it receives a connection request.

  Timeout
Stop connecting to passive node, if not successful after 10 retries.

After of retries, the connection to passive Node is marked as DISABLED.

It means there is no any retry anymore.

Set to 0 for endless retry.

        Default: 10

  SendControl
Send following control messages after connection is established. Optional.

        Default: disabled

Supported Control messages:

        DLT_SERVICE_ID_GET_LOG_INFO                    0x03
        DLT_SERVICE_ID_GET_DEFAULT_LOG_LEVEL           0x04
        DLT_SERVICE_ID_GET_SOFTWARE_VERSION            0x13

  SendSerialHeader
Send Serial Header with control messages. Value in dlt.conf(5) is used as default if not specified.

        Default: disabled

  SendPeriodicControl
Send following control messages periodically.

        Default: disabled

Format:

        control:interval[in seconds]

AUTHOR
Thanh Bui Nguyen Quoc (thanh.buinguyenquoc (at) vn (dot) bosch (dot) vn)

COPYRIGHT
Copyright (C) 2020 Advanced Driver Information Technology, Bosch and DENSO. License MPL-2.0: Mozilla Public License version 2.0 http://mozilla.org/MPL/2.0/.

BUGS
See Github issue: https://github.com/COVESA/dlt-daemon/issues

SEE ALSO
dlt.conf(5), dlt-daemon(1)