BPFTUNE-NEIGH(8)

NAME
BPFTUNE-NEIGH - Neighbor table bpftune plugin for managing neighbor table sizing

DESCRIPTION
        The neighbor table contains layer 3 -> layer 2 mappings and reachability information on remote systems. We look up via layer 3 address (IP address) to find layer 2 address (MAC address) associated.

        The table is populated with both static and garbage-collected values. When adding entries we can specify that they should be PERMANENT, in which case they are not (exempt from) garbage-collected.

        Periodic garbage collection happens for non-permanent failed or expired entries; it is run immediately if we cannot alloc a new neighbor table entry.

        There are a few pathologies we want to avoid here, principally

            •   neighbor table full: if we see /var/log/messages "Neighbour table overflow." we have run out of space. Can occur if garbage collection isn't run quickly enough or we are full with entries not subject to garbage collection.

                In former case, we could auto-tune by reducing gc_thresh2 since this makes GC run more quickly.

                In the latter case, with a large number (75% or more) of exempt from GC entries, garbage collection won't help so we have to increase gc_thresh3. This is done on a per-table basis via netlink, so the resource costs are limitied rather than setting a system-wide tunable. Size is increased by 25% of the current value (so 1024 -> 1280, etc).

                Note that by increasing gc_thresh3 only, garbage collection gets gets more time to run from table sized gc_thresh2 until we reach gc_thresh3. So it effectively helps with both scenarios.

            •   neighbor table thrashing: too-aggressive GC eviction might lead to excessive overhead in re-estabilishing L3->L2 reachability information. TBD.

        Tunables:

            •   gc_interval: how often garbage collection should happen; default 30 seconds.

            •   gc_stale_time: how often to check for stale entries. If neighbor goes stale, it is resolved again before sending data; defaults to 60sec

            •   base_reachable_time_ms: how long neighbor entry is considered reachable for; defaults to 30sec.

            •   gc_thresh1: with a table size below this value, no GC happens; default 128

            •   gc_thresh2: soft max of entries in table; wait 5 secs if we exceed this value to do GC; default 512.

            •   gc_thresh3: hard max for table size, GC will run if more entries than this exist, default 1024.

        Note: to set table size we need to use the equivalent of "ip ntable"; i.e. "ip ntable change name arp_cache dev eth0 thresh3 1024" (this is done directly in bpftune via netlink)

        Contrast this approach with simply choosing a large net.ipv4.neigh.gc_thresh3. If thresh2 and thresh3 are far apart, we may over-garbage collect, whereas if they are close we may end up keeping around too many entries. In either case, we're mistuned because we've had to choose coarse-grained defaults rather than adapting on a per-table basis as the need arises.

SEE ALSO
        bpf(2), bpftune(8),